Application Instructions
For a smooth, uniform finish, prepare the surface properly according to its material before applying Sarvottam Brighty Synthetic Enamel.
A. Wood Surface Application
Step 1: Prepare New Wooden Surfaces
For new or unpainted wooden surfaces, scrub thoroughly using emery paper to smooth the surface and remove dust, roughness, and loose particles.
Step 2: Prepare Previously Painted Wood
Scrape away blistered, loose, or flaking paint from previously painted wooden surfaces. Ensure all poorly adhering coatings are completely removed.
Step 3: Clean the Surface
Remove oil, grease, polish, wax, smoke residue, and other contaminants. Allow the surface to dry completely before painting.
Step 4: Apply Brighty Synthetic Enamel
Apply two uniform coats of Sarvottam Brighty Synthetic Enamel to the properly prepared wooden surface. Allow adequate drying between coats according to the manufacturer's instructions.
B. Metal Surface Application
Step 1: Remove Rust and Loose Paint
Scrape away rust, scales, loose paint, and other surface contaminants using suitable tools.
Step 2: Sand the Surface
Rub the metal surface thoroughly using emery paper to remove remaining rust and uneven areas.
Step 3: Clean the Metal Surface
The supplied instructions recommend cleaning with a kerosene-dampened cloth where needed, followed by mineral turpentine. Remove all traces of oil, grease, and smoke residue. Observe solvent safety precautions and allow the surface to dry fully.
Step 4: Apply Brighty Synthetic Enamel
Apply two coats of Sarvottam Brighty Synthetic Enamel evenly to the cleaned and dried metal surface, allowing suitable drying time between coats.
C. Masonry Surface Application
Step 1: Check Surface Condition
Ensure that the cement plaster is properly cured and that the masonry surface is suitable for enamel application.
Step 2: Clean the Surface
Remove loose paint, dust, dirt, grease, fungal growth, and other contaminants.
Step 3: Repair Surface Defects
Repair cracks, holes, and other surface imperfections using suitable repair materials.
Step 4: Wash and Dry
Wash the surface with clean water and allow it to dry thoroughly before proceeding.
Step 5: Sand the Surface
Sand the prepared masonry surface to achieve a smooth and even base. Remove any remaining dust.
Step 6: Apply Brighty Synthetic Enamel
Apply two uniform coats of Sarvottam Brighty Synthetic Enamel using suitable painting tools, following the manufacturer's drying recommendations.
Important Application Tips
Always clean and dry the surface before painting.
Remove rust and loose paint completely.
Use emery paper for proper sanding.
Remove oil, grease, polish, and wax residues.
Ensure masonry plaster is properly cured.
Repair cracks and surface imperfections before application.
Apply two uniform coats of enamel.
Follow manufacturer instructions for thinning and recoating.
Maintain adequate ventilation during application.
Keep solvents and paint away from ignition sources.
